Arduino Protoshield PCB

Product Description

Arduino classical prototype shield PCB board, you only need to solder a few parts, which can all be found on our store. This board is slightly different with the other we sells now.
Features:

    It has a nice standard 0.1″x0.1″ prototying grid with big pads
    A IC pattern for adding DIP ICs up to 20 pins
    Power rails down the middle and sides
    A reset button and an extra general use button
    2 3mm general use LEDs, red and green, as well as 2 matching resistors
    The ICSP header is up top if you like to upload to your Arduino using a programmer
    A surface-mount chip area for up to 14 SOIC size parts
    Compatible with either tiny breadboards or ‘standard’ breadboards with the rails removed.
    Every pin is brought out, including the new 3V and Reset header pins
    2 0.1uF capacitors on either side for extra power stability

A BOM for this PCB:

    Break away pin header male
    Arduino special pin header
    3mm dia. LEDs and 1K resistors.
    Buttons
    Decouple capacitor 0.1UF

Documentation:

    Schematic available on request

picture with the pcb (this product)

picture populated with separate spare parts